FREE CONTENT

Learning From the Residents

September 01, 2002
September/October 2002
This article originally appeared in the September/October 2002 issue of Home Energy Magazine.
SHARE
Click here to read more articles about Healthy Homes


        Creating a cutting edge home is exciting, and so is getting a chance to demonstrate to other builders, Realtors, and community residents that the promises of green building can be kept without excessive costs. However, the true test of a highly efficient green home comes when real human beings experience living in it. Six months ago, three nuns from the Humility of Mary Order purchased the first sustainable home in the Cleveland area.This house was built by GreenBuilt Homes, Ltd., a company that I helped create but have since left.The nuns have been living there ever since and providing us with very thoughtful feedback on how the house works.
        As part of her work with the federal Building America program, Betsy Pettit of Building Science Corporation designed the 2,500 ft2 house, which has a conditioned crawlspace. We used the Cold Climate version of Joe Lstiburek’s Builder’s Guide to facilitate the building process.We worked hard to get all the details right, and we must have succeeded fairly well, because the building envelope was tested and proved to meet Building America standards (see “The Complete Test Kit”).
        The house is heated by the same hot water tank—a 50-gallon A.O. Smith Sealed Shot-Powered Direct Vent Water Heater—that provides the water for bathing, laundry, and cooking.This system is direct vented and gets its combustion air through vent pipes that penetrate the roof.As the only other combustion appliance in the house is the stove,we are not very concerned about backdrafting.

Controlling Air Quality

        The hot water line runs through an air handler that delivers forced air through a duct system.Air is returned to the air handler through grilles located in each room that feed into a common return in the hallway. In pressure balance testing conducted by Building Science Corporation’s Armin Rudd, only one of the rooms proved to be overpressurized, and we needed a slightly larger grille there to compensate.There was also some air leakage near the boots because the construction workers who put in the boots had a different take on sealing than did the A/C technicians who built the duct runs.The duct runs were all sealed with mastic.We fixed the missed crawlspace boot seams by sealing them with mastic from the exterior and applied the same treatment from the interior to the boot seams on the second floor.
        A ventilation system designed by Rudd was installed.This system includes a duct from the exterior into the cold air return section of the air handler that has one of Rudd’s AirCycler Smart Ventilation Controllers in it.When the air handler is not delivering conditioned air, this controller brings fresh air into the living space every 20 minutes. The other ventilation devices installed in the house are three bath fans—one is used by both the bath and the adjoining laundry room—and a range hood over the stove that vents directly to the outside. These fans are all manually controlled.
        Other measures we took to improve the indoor air quality (IAQ) of the structure include using countertops made of straw with no formaldehyde bonding agents (ISOBORD) and sealing cabinet edges that had exposed particleboard edges.We also used low volatile organic compound (low-VOC) paints on all the interior walls and trim. And we advocated a shoes-off-at-thedoor policy for the new residents.
        I have long felt that lead dust, pesticides, and other stuff tracked into the house on our feet and deposited on floors and in carpeting is a major source of indoor pollutants. Several years ago,we did lead abatement in several homes and then went back six months later to see if conditions might have changed. We found almost no lead anywhere in the houses, except in the carpet near the front doors. It had been tracked in from outside from soils contaminated with lead paint and lead from auto emissions. There is a growing concern that pesticides may be tracked in from lawns as well.
        For nine months the house was open for visitors who were considering taking the green building plunge. People taking the tour included staff from the community development corporations, builders, realtors, and bankers. I prepared a complete set of displays with photos of the house as it was being constructed; these displays were available in each room of the house and on the exterior. Ohio Senator George Voinovich and federal EPA Administrator Christie Todd Whitman even visited when they were in town to promote the role of private enterprise in accomplishing environmental goals. (I’m glad we had our Building America sign out in front of the house when they came!)
        During the demonstration period, we learned that the house became uncomfortably warm during the late summer months.To be ready to add air conditioning if the new homeowners needed it,we had included an evaporator coil in the air handler when it was installed. We also installed a watt-hour meter to measure the electricity that would be used by an air conditioner. But while nine months of visitors can let a builder know some of what works and what doesn’t in a new house, only full-time residents can truly put a house through its paces.


        The Nuns Weigh In


        After the nuns had a chance to settle in, I began to call them to see how they were experiencing their new living space. My first questions had to do with how effectively the heating system was working. The nuns had moved from a very old house with a typical forced-air heating system that delivered conditioned air at a very high temperature. The heat in their new house was delivered at a considerably lower temperature. Still, they reported that they were basically very comfortable. In fact, when they first moved in, they would set the thermostat back to 68°F each morning before they left for their jobs as Montessori teachers. During the first month in the house, they found that the house would be too warm when they returned, so they started putting the thermostat back to 65°F and that worked reasonably well. It turned out that the late afternoon sun through the west windows was making the house several degrees warmer than the thermostat temperature setting.
        Moisture hasn’t been a problem so far; moisture levels have remained near a constant 35% relative humidity (RH) as measured by an inexpensive hygrometer that was placed on a balcony overlooking the living/dining area. When the nuns are in the bathroom, they always use the bath fan, and they never cook without turning on the range hood fan. No moisture has appeared on the Andersen windows. The humidity level on a cheap, instantaneous-reading hygrometer I had installed in the floor trusses in the crawlspace has remained well below 50% RH.
        I was particularly concerned with the rate of air changes in the house, and with whether the CO2 levels were appropriate. Measured CO2 levels can indicate whether sufficient ventilation air is being provided to dilute pollutants generated by the people in a house. I provided the nuns with a Telaire 7001 CO2 and Temperature Monitor and asked them to write down the readings on four occasions during the day and to note what activities were going on when the monitor was registering too high or too low levels of CO2.They kept a careful record over a four-week period, and the results were most satisfying (see Table 1).
        The Telaire Ventilation Rate Conversion Chart suggests a range of 650–800 ppm CO2 as ideal ventilation. Less than 650 ppm means that energy is being wasted because the house is overventilated. More than 800 ppm means that the house is underventilated, and IAQ is poor. Another guideline to use that Leadership in Energy and Environmental Design (LEED) recommends is that indoor CO2 levels should not be more than 530 ppm higher than the CO2 levels found outdoors. (If outdoor CO2 levels are high, it is very difficult to get low levels indoors. Base outdoor levels generally are in the 350–390 ppm range.) Over the four weeks, the average reading was 747 ppm, but there were two occasions when the readings went over 1,100 ppm.
        The first incident occurred the first time the nuns used the oven for an extended period. They had been careful to use the range hood fan when using the stove top, but they had neglected to do so when using the oven. One of the nuns, who had become very interested in their home’s performance and who frequently checked the meter just for fun, happened to notice that the CO2 level was very high.They thought about what might be causing the problem and quickly concluded that the oven was the source of the excess CO2. They turned on the range hood fan, and within an hour CO2 levels were back to normal. Since then, they routinely turn on the fan when using the oven and the problem has not recurred.
        The second incident occurred when they invited a group over for the evening. At some point they noticed that the CO2 level had gotten quite high and assumed that it was because of the additional people in the house. Their solution was to turn on the bath fan in the second-floor bathroom.Within an hour or so, the CO2 level began to drop, and by the next morning, it was normal again. During a more recent group meeting, they started the second- floor bath fan soon after the first guest arrived, and the CO2 level never got inappropriately high.
        This brief study taught me a compelling lesson: It was the very act of creating a comprehensive, controlled ventilation strategy that permitted these women to notice and solve the temporary ventilation problems they were having in their house. Is it necessary for us to put a CO2 detector in every house we build? No. What is important is that we learn what conditions trigger higher or lower CO2 levels and what the residents can do about it. The more effectively we tighten and ventilate a home, the more likely it is that the residents will be able to maintain a healthy IAQ on their own with minimal energy loss.
        A side benefit of all of our efforts to produce a healthy indoor environment in this home occurred when another member of the nuns’ order spent most of a day with them in their home. This person has asthma that is triggered by numerous environmental causes. After several hours visiting with her colleagues, she noted that she had not felt so comfortable in any indoor space in a long time.

Future Data Mining

        We look forward to finding out exactly how the house performs in really hot weather. During this summer we will be monitoring the CO2 levels for several weeks while the air conditioning is in operation to determine how effectively air is being changed during cooling conditions. The information we gather during this time, together with the cost of electricity for the air conditioner use, will give us a pretty good idea of what it costs per year to operate a healthy and comfortable house in this climate.
        We have installed several small, battery-powered temperature and humidity data loggers (HOBOs) in the house and on the detached garage.We will download data from them early this fall to get a picture of temperature and humidity throughout the structure during both winter and summer. I expect that we will learn a few more lessons that can be passed on to others who have the opportunity to live in tight, energy-efficient, and effectively vented living spaces.

  • 1
  • FIRST PAGE
  • PREVIOUS PAGE
  • NEXT
  • LAST
Click here to view this article on a single page.
© Home Energy Magazine 2014, all rights reserved. For permission to reprint, please send an e-mail to contact@homeenergy.org.
Discuss this article in the HVAC group on Home Energy Pros!

Comments
Add a new article comment!

Enter your comments in the box below:

(Please note that all comments are subject to review prior to posting.)

 

While we will do our best to monitor all comments and blog posts for accuracy and relevancy, Home Energy is not responsible for content posted by our readers or third parties. Home Energy reserves the right to edit or remove comments or blog posts that do not meet our community guidelines.

Related Articles
Email Newsletter

Home Energy E-Newsletter

Sign up for our free monthly
E-Newsletter!

Harness the power of
HOME PERFORMANCE!

Get the Home Energy
e-newsletter

FREE!

SUBSCRIBE

NOW!